Configuring Ospfv3 Features (Cli); Configuring Global Ospfv3 Settings - Dell PowerConnect 7048P Manual

Configuring OSPFv3 Features (CLI)

This section provides information about the commands you use to configure
OSPFv3 settings on the switch. For more information about the commands
and about additional show commands, see the
CLI Reference Guide

Configuring Global OSPFv3 Settings

Beginning in Privileged EXEC mode, use the following commands to
configure various global OSPFv3 settings for the switch.
Command
configure
ipv6 router ospf
ip-address
router-id
auto-cost reference-
ref_bw
bandwidth
default-information
originate [always]
metric-value
[metric
type-value
[metric-type
metric-
default-metric
value
.
Purpose
Enter global configuration mode.
Enter OSPFv3 configuration mode.
Set the 4-digit dotted-decimal number that uniquely
identifies the router.
Set the reference bandwidth used in the formula to
compute link cost for an interface:
link cost = ref_bw÷interface bandwidth
ref_bw
The variable is the reference bandwidth in Mbps
(Range: 1–4294967).
Control the advertisement of default routes.
• always — Normally, OSPFv3 originates a default route
]
only if a default route is redistributed into OSPFv3 (and
]
default-information originate is configured). When the
always option is configured, OSPFv3 originates a default
route, even if no default route is redistributed.
metric-value
•
default route. (Range: 1–16777214)
type-value
•
route or External type-2 route.
Set a default for the metric of distributed routes. (Range:
1–16777214).
PowerConnect 7000 Series
— The metric (or preference) value of the
— The value is either 1 or 2: External type-1
Configuring OSPF and OSPFv3
981