Configuring Ospfv3 Route Redistribution Settings - Dell PowerConnect 7048P Manual

Configuring OSPFv3 Route Redistribution Settings

Beginning in Privileged EXEC mode, use the following commands to
configure OSPFv3 route redistribution settings.
Command
configure
ipv6 router ospf
redistribute {static |
connected} [metric
metric
] [metric-type {1 |
tag
2}] [tag ]
exit
exit
show ipv6 ospf
Purpose
Enter global configuration mode.
Enter OSPFv3 configuration mode.
Configure OSPFv3 to allow redistribution of routes from
the specified source protocol/routers.
• static — Specifies that the source is a static route.
• connected — Specifies that the source is a directly
connected route.
metric
• — Specifies the metric to use when
redistributing the route. (Range: 0–16777214)
• metric-type 1 — Type 1 external route.
• metric-type 2 — Type 2 external route.
tag
• — Value attached to each external route, which
might be used to communicate information between
ASBRs. (Range: 0–4294967295)
Exit to Global Config mode.
Exit to Privileged EXEC mode.
View OSPFv3 configuration and status information,
including information about redistributed routes.
Configuring OSPF and OSPFv3
989