Configuring Basic Network Information (Cli); Enabling The Dhcp Client On The Oob Port; Enabling The Dhcp Client On The Default Vlan - Dell PowerConnect 7048P Manual

Configuring Basic Network Information (CLI)

This section provides information about the commands you use to configure
basic network information on the PowerConnect 7000 Series switch. For more
information about these commands, see the
Reference Guide

Enabling the DHCP Client on the OOB Port

Beginning in Privileged EXEC mode, use the following commands to enable
the DHCP client on the OOB port.
Command
configure
interface out-of-band
ip address dhcp
CTRL + Z
show ip interface out-of-
band

Enabling the DHCP Client on the Default VLAN

Beginning in Privileged EXEC mode, use the following commands to enable
the DHCP client on the default VLAN, which is VLAN 1.
Command
configure
interface vlan 1
ip address dhcp
ipv6 address dhcp
CTRL + Z
show ip interface vlan 1 Display network information for VLAN 1.
128
Setting Basic Network Information
.
Purpose
Enter Global Configuration mode.
Enter Interface Configuration mode for the OOB port.
Enable the DHCP client.
Exit to Privileged EXEC mode.
Display network information for the OOB port.
Purpose
Enter Global Configuration mode.
Enter Interface Configuration mode for VLAN 1.
Enable the DHCP client.
Enable the DHCPv6 client.
Exit to Privileged EXEC mode.
PowerConnect 7000 Series CLI