Reset Button; Port And System Leds; Stack Master Led And Stack Number Display - Dell PowerConnect 7048P Manual

Powerconnect 7000 series stackable layer 2 and 3 switches

Hide thumbs Also See for PowerConnect 7048P:

Table of Contents

Reset Button

The reset button is accessed through the pinhole and allows you to perform a

hard reset on the switch. To use the reset button, insert an unbent paper clip

or similar tool into the pinhole. When the switch completes the boot process

after the reset, it resumes operation with the most recently saved

configuration. Any changes made to the running configuration that were not

saved to the startup configuration prior to the reset are lost.

The front panel contains light emitting diodes (LEDs) that indicate the

status of port links, power supplies, fans, stacking, and the overall system.

Additionally, the PowerConnect 7024P and PowerConnect 7048P switches

contain LEDs that provide information about Power over Ethernet Plus

(PoE+) status and activity on the ports.

For information about the status that the LEDs indicate, see "LED

Definitions" on page 91.

When a switch within a stack is the master unit, the stack master LED, which

is labeled M, is solid green. If the M LED is off, the stack member is not the

master unit. The Stack No. panel displays the unit number for the stack

member. If a switch is not part of a stack, the M LED is illuminated and the

stack unit number is 1.

Hardware Overview