Route Entry Configuration (Switch Default Gateway) - Dell PowerConnect 7048P Manual

4 If you select Manual for the configuration method, specify the IP Address
and Subnet Mask in the appropriate fields.
5 Click Apply.
NOTE:
You do not need to configure any additional fields on the page. For
information about VLAN routing interfaces, see "Configuring Routing Interfaces"
on page 843.

Route Entry Configuration (Switch Default Gateway)

Use the Route Entry Configuration page to configure the default gateway for
the switch. The Default VLAN uses the switch default gateway as its default
gateway.
To display the Route Entry Configuration page, click Routing → Router →
Route Entry Configuration in the navigation panel.
Figure 7-3. Route Configuration (Default VLAN)
Configuring a Default Gateway for the Switch:
To configure the switch default gateway:
1 Open the Route Entry Configuration page.
2 From the Route Type field, select Default.
122
Setting Basic Network Information