Configuring Basic Network Information (Cli); Enabling The Dhcp Client On The Oob Port; Enabling The Dhcp Client On The Default Vlan - Dell PowerConnect 8024 User Configuration Manual

Configuring Basic Network Information (CLI)

This section provides information about the commands you use to configure
basic network information on the PowerConnect 8024/8024F switch. For
more information about these commands, see the
CLI Reference Guide

Enabling the DHCP Client on the OOB Port

Beginning in Privileged EXEC mode, use the following commands to enable
the DHCP client on the OOB port.
Command
configure
interface out-of-band
ip address dhcp
CTRL + Z
show ip interface out-of-
band

Enabling the DHCP Client on the Default VLAN

Beginning in Privileged EXEC mode, use the following commands to enable
the DHCP client on the default VLAN, which is VLAN 1.
Command
configure
interface vlan 1
ip address dhcp
ipv6 address dhcp
CTRL + Z
show ip interface vlan 1 Display network information for VLAN 1.
118
Setting Basic Network Information
at support.dell.com/manuals.
Purpose
Enter Global Configuration mode.
Enter Interface Configuration mode for the OOB port.
Enable the DHCP client.
Exit to Privileged EXEC mode.
Display network information for the OOB port.
Purpose
Enter Global Configuration mode.
Enter Interface Configuration mode for VLAN 1.
Enable the DHCP client.
Enable the DHCPv6 client.
Exit to Privileged EXEC mode.
PowerConnect 8024/8024F