Removing The Processor; Figure 11. Opening The Load Plate - Intel SR1680MV - Server System - 0 MB RAM Service Manual

You can install single or dual processors on the motherboard according to your own needs.
1. If a SINGLE processor is intended, it is recommended that you install the processor
on the processor 1 socket. Refer to Figure 10.
2. If installing DUAL processors, use the same type of processor running at the same
frequency.
Note: Before you remove or install the heatsink, processor or heatsink socket, complete the
following steps:
1. Make sure the server is not turned on or connected to the AC power. To power off
the server, see
2. Remove the chassis cover. To remove the cover, see

Removing the Processor

1. Unlock the load lever and lift it up.
2. Open the load plate.
3. Lift the processor out of the socket.
®
Intel Server System SR1680MV Service Guide
"Power Off"

Figure 11. Opening the Load Plate

"Mid-Top Cover".
13