Removing An Hdd Backplane; Installing A 2.5-Inch Pluggable Sata Hdd Backplane; System Fans; Figure 38. Remove The Screws And Lift The Backplane Up - Intel SR1680MV - Server System - 0 MB RAM Service Manual

Note: Before you remove or install the power supply, complete the following steps:
1. Make sure the server is not turned on or connected to the AC power. To power off
the server, see
2. Remove the motherboard cage module. To remove the cover, see
Server Board Cage
3. Disconnect all necessary cable connections.

Removing an HDD Backplane

1. Loosen the two securing screws on the backplane.
2. Lift the backplane up from motherboard.

Installing a 2.5-inch Pluggable SATA HDD Backplane

Reverse the
HDD backplane.

System Fans

Each I/O board cage module includes three system fans. The six system fans on the server
system share the same removal and installation procedures. For your reference, this
section provides the steps for replacing one system fan on the right I/O board cage module
as an example.
The following figure shows the location of the system fan on the right I/O board cage
module:
®
Intel Server System SR1680MV Service Guide
"Power Off".
Module".

Figure 38. Remove the Screws and Lift the Backplane Up

"Removing an HDD Backplane" steps to install the 2.5-inch pluggable SATA
"Removing the
33