Other Settings; Misc. Settings - HP Jetdirect J7974E Administrator's Manual

Other Settings

This item provides access to a variety of management and printing configuration options. The following
tabs are provided:
●
Misc. Settings: for enabling miscellaneous advanced protocols and functions
●
Firmware Upgrade
●
LPD Queues
services
●
Support
●
Refresh

Misc. Settings

The Miscellaneous Settings parameters allow you to set a variety of advanced protocols and features,
as described below. See
Table 4-12 Miscellaneous Settings
Item
SLP Config
Telnet Config
Bonjour
Multicast IPv4
9100 Config
FTP Printing
LPD Printing
IPP Printing
76 Chapter 4 HP Jetdirect Embedded Web Server (V.34.xx)
: to update your HP Jetdirect print server with new features and enhancements
: for setting up print queues used in printing under LPD (line printer daemon) printing
Info: to set up the Support link located under Other Links in the left margin
Rate: to set the time interval (in seconds) for embedded Web diagnostic page updates
Table 4-12 Miscellaneous
Description
Enable or disable SLP (Service Location Protocol), used by selected client application
software to automatically discover and identify the HP Jetdirect print server.
If SLP will use multicast protocols, Multicast IPv4 must be enabled.
Enable or disable access to HP Jetdirect configuration parameters using Telnet. For more
information, see
Enable or disable Bonjour services (formerly listed as Multicast Domain Name System, or
mDNS, services). Bonjour is typically used for IP address and name resolution (through
UDP port 5353) where a conventional DNS server is not used.
For Bonjour operation, Multicast IPv4 must be enabled.
Enable or disable the receipt and transmission of IP version 4 multicast packets by the
print server. If this parameter is disabled, other protocols that use multicast protocols, such
as Bonjour and SLP, may also be disabled without notification.
Enable or disable port 9100 services. Port 9100 is an HP-proprietary raw TCP/IP port on
the HP Jetdirect print server and is the default port for printing. It is accessed by HP
software (for example, the HP Standard Port).
Enable or disable File Transfer Protocol services available on the HP Jetdirect print server
for printing. For more information, see
Enable or disable the Line Printer Daemon services on the HP Jetdirect print server. LPD
on the HP Jetdirect print server provides line printer spooling services for TCP/IP systems.
For more information, see
Enable or disable the Internet Printing Protocol on the HP Jetdirect print server. If the printer
is properly connected and accessible, IPP allows printing to this device over the Internet
(or intranet). A properly configured IPP client system is also required. For information on
IPP client software, see
Settings.
TCP/IP Configuration.
NOTE If this parameter is disabled, other protocols that use multicast protocols,
such as Bonjour and SLP, may also be disabled without notification.
LPD Printing.
HP Software Solutions
FTP Printing.
Summary.
ENWW