Boot Drive; Replacing An Ide Dom (If Present); Figure 51. Lifting Left Side Of Drive Tray Assembly - Intel SS4200-E - Entry Storage System NAS Server User Manual

Boot Drive

The Intel
or storage software.
If the system is running an Intel storage management stack, it will contain an IDE DOM
(disk on module) on the system board. This DOM contains the operating system and any
management software. IDE DOMs require power to be provided by the storage system
using the P4 power cable that is provided as part of the power supply harness. The P4
power cable needs to be attached to the power adapter cable that came with your IDE
DOM.
If your system does not contain an IDE DOM, refer to the documentation provided by
your third-party vendor(s) for instructions on installing storage software.

Replacing an IDE DOM (if present)

Caution: Before performing any maintenance on the system, back up the data.
Note: Refer to your vendor's documentation for procedures on replacing storage system
software.
1. Observe all safety and ESD precautions listed in
2. Turn off all peripheral devices connected to the storage system. Power down the
storage system.
3. Disconnect the AC power cord.
4. Remove the enclosure cover. For instructions, see
on page
5. Lift the left side of the drive tray assembly (see letter "A" in the following figure).
Intel® Entry Storage System SS4200-E User Guide
®
Entry Storage System SS4200-E has two options for loading operating systems
20.

Figure 51. Lifting Left Side of Drive Tray Assembly

Hardware Installations and Upgrades
"Safety Information" on page
"Removing the Enclosure Cover"
85.
47