Hardware Installations and Upgrades
Installing a Hard Drive
1. Observe all safety and ESD precautions listed in
2. Turn off all peripheral devices connected to the storage system. Power down the
storage system.
3. Disconnect the AC power cord.
4. Remove the enclosure cover. For instructions, see
on page
5. Remove the four RVR (rotational vibration reduction) screws from the drive retention
bracket. See letter "A" in the following figure.
Note: RVR screws may be removed either prior to lifting the drive retention bracket
Note: Spare RVR screws are located at the front of the system, inside, by the front
22
20.
or after lifting the drive retention bracket.
panel board.
Figure 18. Removing RVR Screws
"Safety Information" on page
"Removing the Enclosure Cover"
Intel® Entry Storage System SS4200-E User Guide
85.