Configuring Vpls With Bgp Signaling On A Pe Router; Configuring Vpls Instances With Bgp Signaling; Table 114: Commands To Configure Basic Vpls Instances - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - BGP AND MPLS CONFIGURATION GUIDE 2010-10-12 Configuration Manual
Software for e series broadband services routers bgp and mpls configuration guide
Hide thumbs
Also See for JUNOSE SOFTWARE FOR E SERIES 11.3.X - BGP AND MPLS CONFIGURATION GUIDE 2010-10-12:
- Configuration manual (786 pages)
Table of Contents
Advertisement
JunosE 11.3.x BGP and MPLS Configuration Guide
Configuring VPLS with BGP Signaling on a PE Router
Related
Documentation
Configuring VPLS Instances with BGP Signaling
598
To configure VPLS with BGP signaling on the PE router:
Configure a single instance of VPLS, known as a VPLS instance, on the PE router for
1.
each VPLS domain in which the router participates.
(Optional) Configure BGP multihoming for the customer site.
2.
(Optional) Configure optional attributes for the VPLS instance.
3.
Configure network interfaces to connect the PE router to each CE device.
4.
(Optional) Configure nondefault subscriber policies for the VPLS network interface.
5.
Configure a loopback interface and assign a router ID that uses the IP address of the
6.
loopback interface.
Configure MPLS label-switched paths (LSPs) to connect local and remote PE routers.
7.
Set up BGP signaling on the autonomous system configured to signal reachability for
8.
this VPLS instance.
Configuring VPLS Instances with BGP Signaling on page 598
Configuring Optional Attributes for VPLS Instances on page 601
Configuring VPLS Network Interfaces on page 602
Subscriber Policies for VPLS Network Interfaces Overview on page 585
Configuring the Loopback Interface and Router ID for VPLS on page 603
Configuring MPLS LSPs for VPLS on page 604
Configuring BGP Signaling for VPLS on page 604
See Example: Configuring VPLS with BGP Signaling on page 606 for a detailed sample
configuration.
You must configure a VPLS instance for each VPLS domain in which the router
participates. From a configuration standpoint, a VPLS instance is simply a new or existing
bridge group that you configure with additional VPLS attributes.
Table 114 on page 598 lists the commands that you use to configure a basic VPLS instance,
as described in this section.
Table 114: Commands to Configure Basic VPLS Instances
bridge vpls rd
bridge vpls route-target
bridge vpls site-name site-id
bridge vpls site-range
bridge vpls transport-virtual-routers
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
Troubleshooting
