Manually Configuring Internet And Wan Settings; Understanding The Internet And Wan Configuration Tasks - NETGEAR UTM25-100NAS - Prosecure Utm Appliance 25U No Sub Included Reference Manual

Manually Configuring Internet and WAN Settings

Note: The initial Internet configuration of the UTM is described in
Setup Wizard to Provision the UTM in Your
Wizard to configure your Internet settings, you need this chapter only to configure
WAN features such as Dual WAN and Dynamic DNS, and to configure secondary
WAN addresses and advanced WAN options.
This chapter contains the following sections:
•

"Understanding the Internet and WAN Configuration Tasks

• "Configuring the Internet Connections" on page
• "Configuring the WAN Mode (Required for the UTM25's Dual WAN Mode)" on page
• "Configuring Secondary WAN Addresses" on page
• "Configuring Dynamic DNS" on page
• "Configuring Advanced WAN Options" on page
Understanding the Internet and WAN Configuration Tasks
Generally, five steps are required to complete the Internet connection of your UTM:
1. Configure the Internet connections to your ISP(s). During this phase, you connect to your
ISPs. You can also program the WAN traffic meters at this time if desired. See
the Internet Connections" on page
2. Configure the WAN mode (required for the UTM25's dual WAN operation). For both the
UTM10 and UTM25, select either NAT or classical routing. For the UTM25 only, select either
dedicated (single WAN) mode, auto-rollover mode, or load balancing mode. For the UTM25's
load balancing, you can also select any necessary protocol bindings. See
WAN Mode (Required for the UTM25's Dual WAN Mode)" on page
3. Configure secondary WAN addresses on the WAN ports (optional). Configure aliases for
each WAN port. See
3-19.
3-2.
"Configuring Secondary WAN Addresses" on page
v1.0, September 2009
Network." If you used the Setup
on this page.
3-2.
3-17.
3-22.
3-9.
Chapter 3
Chapter 2, "Using the
3-9.
"Configuring
"Configuring the
3-17.
3-1