Configuring The Internet Connections; Automatically Detecting And Connecting - NETGEAR UTM25-100NAS - Prosecure Utm Appliance 25U No Sub Included Reference Manual

ProSecure Unified Threat Management UTM10 or UTM25 Reference Manual
4. Configure dynamic DNS on the WAN ports (optional). Configure your fully qualified
domain names during this phase (if required). See
5. Configure the WAN options (optional). Optionally, you can enable each WAN port to
respond to a ping, and you can change the factory default MTU size and port speed. However,
these are advanced features and changing them is not usually required. See
Advanced WAN Options" on page
Each of these tasks is detailed separately in this chapter.
Note: For information about how to configure the WAN meters, see
Traffic Meter" on page

Configuring the Internet Connections

Note: The initial Internet configuration of the UTM is described in
Setup Wizard to Provision the UTM in Your
Wizard to configure your Internet settings, you need this section only if you want
to make changes to your Internet connections.
To set up your UTM for secure Internet connections, you configure WAN ports 1 and 2. The Web
Configuration Manager offers two connection configuration options:
• Automatic detection and configuration of the network connection.
• Manual configuration of the network connection.
Each option is detailed in the sections following.

Automatically Detecting and Connecting

To automatically configure the WAN ports for connection to the Internet:
1. Select Network Config > WAN Settings from the menu. On the UTM25, the WAN Settings
tabs appear, with the WAN1 ISP Settings screen in view (see
shows the UTM25 screen). On the UTM10, the WAN ISP screen displays.
3-2
"Configuring Dynamic DNS" on page
3-22.
11-1.
Manually Configuring Internet and WAN Settings
v1.0, September 2009
"Configuring
"Enabling the WAN
Chapter 2, "Using the
Network." If you used the Setup
Figure 3-1 on page
3-19.
3-3, which