Table of Contents
Advertisement
ProSecure Unified Threat Management UTM10 or UTM25 Reference Manual
Table 11-17. Schedule Report Settings (continued)
Setting
Reports
Send Report by
Email
Report List
Number of
Reports to Keep
4. Click Apply to save your settings.
Using Diagnostics Utilities
The UTM provides diagnostic tools that help you analyze traffic conditions and the status of the
network. Two sets of tools are available:
•
Network diagnostic tools. These tools include a ping utility, traceroute utility, and DNS
lookup utility, and the option to display the routing table.
•
Traffic diagnostic tools. These tools allow you to perform real-time, per-protocol traffic
analysis between specific source and destination addresses and let you generate reports on
network usage in your network.
Note: For normal operation, diagnostic tools are not required.
To display the Diagnostics screen, select Monitoring > Diagnostics from the menu. To facilitate
the explanation of the tools, the Diagnostics screen is divided and presented in this manual in three
figures
(Figure 11-26 on page
11-47).
Monitoring System Access and Performance
Description (or Subfield and Description)
Select one or more checkboxes to specify the reports that are generated:
• Email Reports.
• Web Reports.
• System Reports.
Note: You can select all three checkboxes, but you might generate a very large
report.
Select this checkbox to enable the UTM to send the report to the recipients that
you must specify below.
Recipients
The e-mail addresses of the report recipients.
Note: Use commas to separate email addresses.
Enter the number of reports that the UTM saves. The maximum number is 12.
11-44,
Figure 11-27 on page
v1.0, September 2009
11-46, and
Figure 11-28 on page
11-43
Advertisement
Table of Contents
Troubleshooting
