NETGEAR UTM25-100NAS - Prosecure Utm Appliance 25U No Sub Included Reference Manual page 251

ProSecure Unified Threat Management UTM10 or UTM25 Reference Manual
3. Complete the fields and select the radio buttons as explained
Table 7-14.
RADIUS Client
Item
Primary RADIUS Server
Select the Yes radio button to enable and configure the primary RADIUS server, and then enter the
settings for the three fields below. The default setting is that the No radio button is selected.
Primary Server IP Address
Secret Phrase
Primary Server NAS
Identifier
Backup RADIUS Server
Select the Yes radio button to enable and configure the backup RADIUS server, and then enter the
settings for the three fields below. The default setting is that the No radio button is selected.
Backup Server IP Address
Secret Phrase
Backup Server NAS
Identifier
Connection Configuration
Time out period
Maximum Retry Counts
4. Click Apply to save your settings.
Virtual Private Networking Using IPsec Connections
Settings
Description (or Subfield and Description)
The IP address of the primary RADIUS server.
The a shared secret phrase to authenticate the transactions between the
client and the primary RADIUS server. The same Secret Phrase must be
configured on both the client and the server.
The primary Network Access Server (NAS) identifier that must be present
in a RADIUS request.
Note: The UTM functions as a NAS, allowing network access to external
users after verification of their authentication information. In a RADIUS
transaction, the NAS must provide some NAS identifier information to the
RADIUS server. Depending on the configuration of the RADIUS server,
the UTM's IP address might be sufficient as an identifier, or the server
might require a name, which you must enter in this field.
The IP address of the backup RADIUS server.
The a shared secret phrase to authenticate the transactions between the
client and the backup RADIUS server. The same Secret Phrase must be
configured on both the client and the server.
The backup Network Access Server (NAS) identifier that must be present
in a RADIUS request.
Note: See the Note above for the Primary Server NAS Identifier.
The period in seconds that the UTM waits for a response from a RADIUS
server.
The maximum number of times that the UTM attempts to connect to a
RADIUS server.
v1.0, September 2009
Table 7-14.
7-41