Ssl Vpn Wizard Step 4 Of 6: Client Ip Address Range And Routes - NETGEAR UTM25-100NAS - Prosecure Utm Appliance 25U No Sub Included Reference Manual

ProSecure Unified Threat Management UTM10 or UTM25 Reference Manual

SSL VPN Wizard Step 4 of 6: Client IP Address Range and Routes

Figure 8-5
Note that Figure 8-5 contains some examples. Enter the settings as explained in
page 8-10, then click Next to go the following screen.
Note: Do not enter an existing route for a VPN tunnel client in the Destination Network
and Subnet Mask fields, otherwise the SSL VPN Wizard will fail and the UTM
will reboot to recover its configuration.
Note: After you have completed the steps in the SSL VPN Wizard, you can make changes
to the client IP address range and routes by selecting VPN > SSL VPN > SSL
VPN Client. For more information about client IP address range and routes
settings, see
Virtual Private Networking Using SSL Connections
"Configuring the SSL VPN Client" on page
v1.0, September 2009
Table 8-4 on
8-25.
8-9