Using The Ipsec Vpn Wizard For Client And Gateway Configurations; Creating Gateway-To-Gateway Vpn Tunnels With The Wizard - NETGEAR UTM25-100NAS - Prosecure Utm Appliance 25U No Sub Included Reference Manual

ProSecure Unified Threat Management UTM10 or UTM25 Reference Manual
Using the IPsec VPN Wizard for Client and Gateway
Configurations
You can use the IPsec VPN Wizard to configure multiple gateway or client VPN tunnel policies.
The section below provides wizard and NETGEAR
procedures for the following scenarios:
• Using the wizard to configure a VPN tunnel between two VPN gateways.
• Using the wizard to configure a VPN tunnel between a VPN gateway and a VPN client.
Configuring a VPN tunnel connection requires that all settings on both sides of the VPN tunnel
match or mirror each other precisely, which can be a daunting task. The VPN Wizard efficiently
guides you through the setup procedure with a series of questions that determine the IPsec keys
and VPN policies it sets up. The VPN Wizard also configures the settings for the network
connection: security association (SA), traffic selectors, authentication algorithm, and encryption.
The settings that are used by the VPN wizard are based on the recommendations of the VPN
Consortium (VPNC), an organization that promotes multi-vendor VPN interoperability.

Creating Gateway-to-Gateway VPN Tunnels with the Wizard

Figure 7-3
To set up a gateway-to-gateway VPN tunnel using the VPN Wizard.
1. Select VPN > IPsec VPN from the menu. The IPsec VPN submenu tabs appear, with the IKE
Policies screen in view.
2. Click the VPN Wizard submenu tab. The VPN Wizard screen displays (see
page 7-4, which contains some examples for the UTM25). The WAN1 and WAN2 radio
buttons are shown on the VPN Wizard screen for the UTM25 but not on the VPN Wizard
screen for the UTM10.
Virtual Private Networking Using IPsec Connections
ProSaf
e VPN Client Software configuration
v1.0, September 2009
Figure 7-4 on
7-3