NETGEAR UTM25-100NAS - Prosecure Utm Appliance 25U No Sub Included Reference Manual page 28

ProSecure Unified Threat Management UTM10 or UTM25 Reference Manual
The front panel also contains three groups of status indicator light-emitting diodes (LEDs),
including Power and Test LEDs, LAN LEDs, and WAN LEDs, all of which are explained in
Table 1-1.
Power LED
USB port
Test LED
Figure 1-2
Note: Figure 1-2
port (the left WAN port that is shown in
The function of each LED is described in
Table 1-1. LED Descriptions
Object Activity
Power On (Green)
Off
Test On (Amber) during
startup.
On (Amber) during
any other time
Blinking (Amber)
Off
1-10
Left LAN LEDs
Right LAN LEDs
shows the UTM25 with two WAN ports. The UTM10 has a single WAN
Table 1-1.
Description
Power is supplied to the UTM.
Power is not supplied to the UTM.
Test mode: The UTM is initializing. After approximately 2 minutes,
when the UTM has completed its initialization, the Test LED goes off.
The initialization has failed or a hardware failure has occurred.
Writing to flash memory (during upgrading or resetting to defaults).
The system has booted successfully.
v1.0, September 2009
DMZ LED
Left WAN LEDs
Right WAN LEDs
Figure 1-2) and no Active WAN LEDs.
Active
WAN
LEDs
Introduction