Configuring The Http Proxy Settings - NETGEAR STM150 Appliance Reference Manual

ProSecure Web/Email Security Threat Management (STM) Appliance Reference Manual
Table 3-2. Session Limits Settings
Setting Description (or Subfield and Description)
Session Limits
Select the Yes radio button to enable session limits, and then specify the Limit Type
and Limit Value fields. The No radio button is selected by default.
Limit Type
Do You Want to
Enable per-user
Session Limits?
Limit Value
The Total Number of Packets Dropped field, which you cannot configure, shows the
total number of packets that are dropped because the session limit has been
exceeded.
Session Timeouts
If a session goes without data flow longer than the configured values, the session is terminated.
TCP Timeout The time in seconds after which a TCP session without data flow is terminated. The
default time is 1200 seconds.
UDP Timeout The time in seconds after which an UDP session without data flow is terminated. The
default time is 180 seconds.
ICMP Timeout The time in seconds after which an ICMP session without data flow is terminated.
The default time is 8 seconds.
4. Click Apply to save your settings. Changing any settings in the Session Timeouts section of
the screen requires the STM to restart. If you click Reset, the STM restarts to restore the
default network settings.

Configuring the HTTP Proxy Settings

If you have used the Setup Wizard, you might have already configured an HTTP proxy; the HTTP
Proxy screen allows you to modify these settings.
If the STM is installed behind an HTTP proxy, you might need to specify the HTTP proxy settings
for the STM to connect to the Internet. The settings on the HTTP Proxy screen affect Web category
filtering, Distributed Spam Analysis, and software updates.
Performing Network and System Management
From the Limit Type pull-down menu, make one of the following
selections:
• Percentage of Maximum Sessions. Session limits are set as a
percentage of the the total connection capacity per user.
• Sessions per User. Session limits are set as an absolute number.
Depending on the selection in the Limit Type field, this value is a
percentage or an absolute number.
v1.0, September 2009
3-7