Default Settings And Technical Specifications - NETGEAR UTM25-100NAS - Prosecure Utm Appliance 25U No Sub Included Reference Manual

Default Settings and Technical Specifications

You can use the reset button located on the rear panel to reset all settings to their factory defaults.
This is called a hard reset (for more information, see
page 10-18).
• To perform a hard reset, press and hold the Reset button for approximately eight seconds (until
the TEST LED blinks rapidly). The UTM returns to the factory configuration settings that are
shown in Table A-1
• Pressing the Reset button for a shorter period of time simply causes the UTM to reboot.
Table A-1 shows the default configuration settings for the UTM.
Table A-1. UTM Default Configuration Settings
Feature
Router Login
User login URL
Administrator user name (case sensitive)
Administrator login password (case sensitive)
Guest user name (case sensitive)
Guest login password (case sensitive)
Internet Connection
WAN MAC address
WAN MTU size
Port speed
Local Network (LAN)
Lan IP address
Subnet mask
RIP direction
RIP version
RIP authentication
Default Settings and Technical Specifications
below.
v1.0, September 2009
"Reverting to Factory Default Settings" on
Default behavior
https://192.168.1.1
admin
password
guest
password
Use default address
1500
AutoSense
192.168.1.1
255.255.255.0
None
Disabled
Disabled
Appendix A
A-1