Table of Contents
Advertisement
ProSecure Unified Threat Management UTM10 or UTM25 Reference Manual
3. Select the Check to Edit Password checkbox. The password fields become active.
4. Enter the old password, enter the new password, and then confirm the new password.
Note: The ideal password should contain no dictionary words from any language, and
should be a mixture of letters (both upper and lower case), numbers, and
symbols. Your password can be up to 30 characters.
5. As an option, you can change the idle timeout for an administrator login session. Enter a new
number of minutes in the Idle Timeout field. (The default setting is 5 minutes.)
6. Click Apply to save your settings.
7. Repeat
step 1
through
Note: After a factory default reset, the password and timeout value are changed back
to password and 5 minutes, respectively.
You can also change the administrator login policies:
•
Deny login access from a WAN interface. By default, the administrator can log in from a WAN
interface.
•
Deny or allow login access from specific IP addresses. By default, the administrator can log in
from any IP address.
Note: For enhanced security, restrict access to as few external IP addresses as
practical.
•
Deny or allow login access from specific browsers. By default, the administrator can log in
from any browser.
In general, these policy settings work well for an administrator. However, if you need to change
any of these policy settings, see
Network and System Management
step 6
for the user with the name 'guest'.
"Setting User Login Policies" on page
v1.0, September 2009
9-12.
10-11
Advertisement
Table of Contents
Troubleshooting
