Table of Contents
Advertisement
ProSecure Unified Threat Management UTM10 or UTM25 Reference Manual
To manually configure the WAN1 ISP (UTM25) or WAN ISP (UTM10) settings:
1. On the UTM25, select Network Configuration > WAN Settings > WAN1 ISP Settings. The
WAN Settings tabs appear, with the WAN1 ISP Settings screen in view (see
page
3-3, which shows the UTM25's screen). On the UTM10, select Network Configuration
> WAN Settings > WAN ISP Settings. The WAN ISP Settings screen displays.
shows the ISP Login section of the screen.
Figure 3-4
2. In the ISP Login section of the screen, select one of the following options:
•
If your ISP requires an initial login to establish an Internet connection, click Yes (this is
the default).
•
If a login is not required, click No and ignore the Login and Password fields.
3. If you clicked Yes, enter the login name in the Login field and the password in the Password
field. This information is provided by your ISP.
4. In the ISP Type section on the screen, select the type of ISP connection that you use from the
three listed options. By default, "Other (PPPoE)" is selected, as shown in
Figure 3-5
3-6
Manually Configuring Internet and WAN Settings
v1.0, September 2009
Figure 3-1 on
Figure 3-4
Figure
3-5.
Advertisement
Table of Contents
Troubleshooting
