NETGEAR UTM25-100NAS - Prosecure Utm Appliance 25U No Sub Included Reference Manual page 345

ProSecure Unified Threat Management UTM10 or UTM25 Reference Manual
4. Click Apply to save your changes.
When remote management is enabled, you must use an SSL connection to access the UTM from
the Internet. You must enter https:// (not http://) and type the UTM's WAN IP address in your
browser .For example, if the UTM's WAN IP address is 172.16.0.123, type the following in your
browser: https://172.16.0.123.
The UTM's remote login URL is:
https://<IP_address> or https://<FullyQualifiedDomainName.
Note: For enhanced security, restrict access to as few external IP addresses as practical.
See "Setting User Login Policies" on page 9-12
administrator access by IP address.
Note: To maintain security, the UTM rejects a login that uses http://address rather than
the SSL https://address.
Note: The first time that you remotely connect to the UTM25 with a browser via an SSL
connection, you might get a warning message regarding the SSL certificate. If you
are using a Windows computer with Internet Explorer 5.5 or higher, simply click
Yes to accept the certificate.
Note: If you are unable to remotely connect to the UTM after enabling HTTPS remote
management, check if other user policies, such as the default user policy, are
preventing access. For access to the UTM's Web Management Interface, check if
administrative access through a WAN interface is granted (see
Policies" on page
Note: If you disable HTTPS remote management, all SSL VPN user connections are also
disabled.
Tip: If you are using a dynamic DNS service such as TZO, you can identify the WAN IP
address of your UTM by running
Trace the route to your registered FQDN. For example, enter
UTM.mynetgear.net,
is displayed.
Network and System Management
9-12).
tracert
and the WAN IP address that your ISP assigned to the UTM
v1.0, September 2009
for instructions on restricting
"Configuring Login
from the Windows Run menu option.
tracert
10-13