NETGEAR UTM25-100NAS - Prosecure Utm Appliance 25U No Sub Included Reference Manual page 362

ProSecure Unified Threat Management UTM10 or UTM25 Reference Manual
Table 11-1. WAN Traffic Meter Settings (continued)
Setting
When Limit is reached
Block traffic
Send e-mail alert An e-mail alert is sent when traffic is blocked. Ensure that e-mailing of logs is
3. Click Apply to save your settings.
4. For the UTM25 only, click the WAN2 Traffic Meter submenu tab. The WAN2 Traffic Meter
screen displays. This screen is identical to the WAN1 Traffic Meter screen (see
page 11-2).
5. For the UTM25 only, repeat
To display a report of the Internet traffic by type, click the Traffic by Protocol option arrow at the
top right of the WAN1 Traffic Meter or WAN2 Traffic Meter screen (UTM25), or at the top right
of the WAN Traffic Meter screen (UTM10). The Traffic by Protocol screen appears in a popup
window. The incoming and outgoing volume of traffic for each protocol and the total volume of
traffic is displayed. Traffic counters are updated in MBs; the counter starts only when traffic
passed is at least 1 MB. In addition, the popup screen displays the traffic meter's start end dates.
Figure 11-2
11-4
Description (or Subfield and Description)
Select one of the following radio buttons to specify what action the UTM performs
when the traffic limit has been reached:
• Block All Traffic. All incoming and outgoing Internet and e-mail traffic is blocked.
• Block All Traffic Except E-Mail. All incoming and outgoing Internet traffic is
blocked but incoming and outgoing e-mail traffic is still allowed.
enabled on the Email and Syslog screen (see
E-mail, and Syslog Logs" on page
step 2 and step 3
v1.0, September 2009
"Configuring and Activating System,
11-6).
for the WAN2 interface.
Monitoring System Access and Performance
Figure 11-1 on