Band Stack Operation - Yaesu FTDX9000D - DATA MANAGEMENT Operation Manual

The FT 9000D utilizes a triple band-stack VFO selection technique, that permits you to store up to three favorite
DX
frequencies and modes onto each band's VFO register. For example, you may store one frequency each on 14 MHz CW,
RTTY, and USB, then recall these VFOs by successive, momentary presses of the [ 14 ] MHz band key. Each Amateur band
key may similarly have up to three frequency/mode settings applied. Both the Main (VFO-A) and Sub (VFO-B) systems
have their own, independent, band stacks.
A typical setup, for the 14 MHz band, might be arranged
like this:
1. Program 14.0250 MHz, CW Mode,
then press the [ 14 ] MHz [ BAND ]
key;
2. Program 14.080 MHz, RTTY Mode,
then press the [ 14 ] MHz [ BAND ]
key;
3. Program 14.195 MHz, SSB Mode,
then press the [ 14 ] MHz [ BAND ]
key.
With this configuration, successive momentary presses of
the [ 14 ] MHz [ BAND ] key will allow you to toggle se-
quentially through these three VFOs.
FT 9000D O
DX PERATION
B S
AND TACK
M
ANUAL
C
ONVENIENT
O
PERATION
[ BAND ] key
BAND Band Stack1
Key
Frequency (MHz) MODE Frequency (MHz) MODE
1.8 1.800000 CW
3.5 3.500000 LSB
5 5.000000 USB
7 7.000000 LSB
10 10.100000 CW 10.100000
14.100000 USB 14.100000
14
18 18.068000 USB 18.068000
21 21.000000 USB 21.000000
24 24.890000 USB 24.890000
28 28.000000 USB 28.000000
50 50.000000 USB 50.000000
15.000000 USB 15.000000
GEN
F
EATURES
Band Stack2 Band Stack3
Frequency (MHz) MODE
1.800000 CW 1.800000 CW
3.500000 LSB 3.500000 LSB
5.000000 USB 5.000000 USB
7.000000 LSB 7.000000 LSB
CW 10.100000 CW
USB
14.100000 USB
USB 18.068000 USB
USB 21.000000 USB
USB 24.890000 USB
USB 28.000000 USB
USB 50.000000 USB
USB
15.000000 USB
Page 55