Convenient Memory Functions - Yaesu FTDX9000D - DATA MANAGEMENT Operation Manual

C M
ONVENIENT EMORY FUNCTIONS
The FT 9000D contains ninety-nine regular memories, labeled 01 through 99, nine special programmed limit memory
DX
pairs, labeled P-1L/1U through P-9L/9U, and five QMB (Quick Memory Bank) memories, labeled C1 ~ C5. Each stores
various settings, not only the main band's (VFO-A) frequency and mode (See below). By default, the 99 regular memories
are contained in one group; however, they can be arranged in up to six separate groups, if desired.
The FT 9000D' memory channels store the following data (not just the operating frequency):
DX
S
Frequency
Mode
Clarifier status and its Offset Frequency
ANT status
IPO status
Roofing filter status and its Bandwidth
Noise Blanker status
CONTOUR status and its Peak Frequency
DSP Noise Reduction (DNR) status and its Reduction algorithm selection.
DSP Notch filter (NTCH) status
NAR bandwidth status
DSP Auto Notch filter (DNF) status
Repeater Shift Direction and CTCSS Tone Frequency
Memory channels may be grouped into as many as six convenient batches, for easy identification and selection. For
example, you might want to set aside memory groups for AM BC stations, shortwave broadcast stations, contest frequen-
cies, repeater frequencies, and PMS limits, or any other groupings you like.
Each memory group is capable of holding up to 20 memory channels (the Group size is fixed). When a memory channel
is grouped, the channel numbers change to correspond to the chart below:
99
98
03
02
01
General
Purpose
Memories
C-1 C-2
QMB QMB
Memories Memories
Page 122
Q Q Q Q Q
UICK UICK UICK
UICK UICK
P-9L/9U
P-8L/8U
P-3L/3U
P-2L/2U
P-1L/1U
PMS
Memories
C-3 C-4 C-5
QMB QMB
QMB
Memories Memories Memories
P P P P P
OINT OINT OINT
OINT OINT
FT 9000D O
DX
M
PERATION ANUAL