Band Stack Operation - Yaesu FTDX9000D Operation Manual

C
ONVENIENT
The FT 9000 utilizes a triple band-stack VFO selection technique, that permits you to store up to three favorite frequen-
DX
cies and modes onto each band's VFO register. For example, you may store one frequency each on 14 MHz CW, RTTY, and
USB, then recall these VFOs by successive, momentary presses of the [14] MHz band key. Each Amateur band key may
similarly have up to three frequency/mode settings applied. Both the Main (VFO-A) and Sub (VFO-B) systems have their
own, independent, band stacks.
A typical setup, for the 14 MHz band, might be arranged
like this:
1. Program 14.0250 MHz, CW Mode,
then press the [14] MHz BAND
key;
2. Program 14.080 MHz, RTTY
Mode, then press the [14] MHz
BAND key;
3. Program 14.195 MHz, SSB Mode,
then press the [14] MHz BAND
key.
With this configuration, successive mo-
mentary presses of the [14] MHz BAND key will allow
you to toggle sequentially through these three VFOs.
Page 54
F
EATURES
B S
AND TACK
O
PERATION
BAND Band Stack1
Key
frequency (MHz) MODE frequency (MHz) MODE
1.8 1.800000 CW
3.5 3.500000 LSB
5 5.000000 USB
7 7.000000 LSB
10 10.100000 CW
14 14.100000 USB
18.068000 USB
18
21 21.000000 USB
24 24.890000 USB
28 28.000000 USB
50 50.000000 USB
GEN 15.000000 USB
FT 9000D O
DX
Band Stack2 Band Stack3
frequency (MHz) MODE
1.800000 CW 1.800000
3.500000 LSB 3.500000
5.000000 USB 5.000000
7.000000 LSB 7.000000
10.100000 CW 10.100000
14.100000 USB 14.100000
18.068000 USB
18.068000
21.000000 USB 21.000000
24.890000 USB 24.890000
28.000000 USB 28.000000
50.000000 USB 50.000000
15.000000 USB 15.000000
M
PERATION ANUAL
CW
LSB
USB
LSB
CW
USB
USB
USB
USB
USB
USB
USB