Vfo And Memory Scanning; Vfo Scanning - Yaesu FTDX9000D - DATA MANAGEMENT Operation Manual

You may scan wither the VFO or the memories of the FT
signal strong enough to open the receiver's squelch.
[ SQL ] knob
1. Press the [ A ] or [ B ] switch to select the VFO to be
scanned.
2. Set the VFO to the frequency on which you would
like to begin scanning.
3. Rotate the [ SQL ] control (for Main band (VFO-A)
scan, for Sub band (VFO-B) scan) so that the back-
ground noise is just silenced.
4. Press and hold in the microphone's [ UP ] or [ DOWN ]
key for 2 second to start scanning in the specified
direction.
FT 9000D O
DX PERATION
DX
VFO S
M
ANUAL
VFO
AND
9000D, and the radio will halt the scan on any station with a
CANNING
[ V/M ] key
If the scanner halts on an incoming signal, the
decimal point between the "MHz" and "kHz"
digits of the frequency display will blink.
If the incoming signal disappears, scanning
will resume in about five seconds.
On the SSB/CW and SSB-based Data modes,
the scanner will pause on a received signal, then
will step across the signal very slowly, giving
you time to stop the scan, if you like. In these
modes on the VFO, the scanner does not stop,
however.
M S
EMORY CANNING
A A A A A
D D D D D VICE VICE VICE
VICE VICE
Page 133