Yaesu FTDX9000D - DATA MANAGEMENT Operation Manual page 119

Text Message Programming
1. Press the [ CW ] mode switch to engage CW operation.
2. Be sure that Break-in is Off by pressing the [ BK-IN/
SPOT ] key, if necessary.
3. Press the FH-2's [ MEM ] key.
LOCK
ON
4. Press the FH-2's [ 1 ] ~ [ 5 ] key to select the desired
Message Memory Register into which you wish to
program the text.
LOCK
ON
5. Use the FH-2's [ ] and [
position and use the [ ] and [ ] keys to choose the
letter/number to be programmed in each slot of the
memory. In the case of the second example above,
the "}" character designates the slot where the Con-
test Number will appear.
A A A A A
D D D D D VICE VICE VICE VICE VICE
You may also use the [ Main Tuning Dial ] knob and
the [ CLAR/VFO-B ] knobs to program the message
characters.
LOCK
ON
6. Press the FH-2's [ MEM ] key again once all charac-
ters have been programmed.
FT 9000D O
DX PERATION
C M
ONTEST
OFF
OFF
] keys to set the cursor
OFF
M
ANUAL
CW C
ONVENIENCE
K
EMORY EYER
Checking the CW Memory Contents
1. Be sure that Break-in is still turned Off.
2. Press the FH-2's [ 1 ] ~ [ 5 ] key to check your work.
You will hear the results in the sidetone, but no RF
energy will be transmitted.
On-The-Air CW Message Playback
1. Press the [ BK-IN/SPOT ] key to enable transmission.
Either Full- or Semi-break-in will be engaged, de-
pending on the setting of Menu item "MODE-CW
055 CW BK-IN."
2. Press the FH-2's [ 1 ] ~ [ 5 ] key to transmit the pro-
grammed message.
N N N N N
O O O O O TE TE TE TE TE
If you subsequently decide to use the "MESSAGE"
technique for memory storage, please note that the
contents of a message stored using text input will not
be transferred over when you select "MESSAGE" on
a particular memory register.
Correcting/Editing Previously-Stored Characters
Use the [ Main Tuning Dial ] knob to select the letter/number
to be corrected, then rotate the [ CLAR/VFO-B ] knob to choose
the revised letter/number top be utilized in this slot.
Deleting Previously-stored Characters
Use the [ Main Tuning Dial ] knob to select the last correct
letter in the message. Now rotate the [ CLAR/VFO-B ] knob to
select the " } " character; everything after the " } " character
will be deleted.
F
EATURES
LOCK
ON OFF
LOCK
ON OFF
Page 117