Memory Channel Recall - Yaesu FTDX9000D - DATA MANAGEMENT Operation Manual

M O
EMORY PERATION
Press the [ V/M ] switch, if necessary, to enter the
1
Memory mode. A memory channel number will ap-
pear in the multi-panel window.
2. Press the [ MCH/GRP ] key momentarily.
The Red LED inside the switch will light up, indicat-
ing that you are ready to recall a memory channel.
A A A A A
D D D D D VICE VICE VICE VICE
VICE
If the Red LED imbedded in the [ MCH/GRP ] switch
does not light up, check to be sure that the orange
lamp to the right of the [ CLAR/VFO-B ] knob is not
illuminated. It is, press the [ A/B ] switch to make it go
out, then press the [ MCH/GRP ] key again.
3. After pressing the [ MCH/GRP ] key, you may rotate
the [ CLAR/VFO-B ] knob to select the desired
memory channel.
Page 126
M C
EMORY HANNEL
[ V/M ] key
R
ECALL
[ MCH/GRP ] switch
Advice
To work within a particular Memory Group, press
and hold in the [ MCH/GRP ] key for two seconds.
The imbedded LED will glow Orange; now press
the [ MCH/GRP ] key momentarily, and the LED
will change to Red; you many now choose the chan-
nel within the selected Memory Group.
FT 9000D O
DX
[ CLAR/VFO-B ] knob
M
PERATION ANUAL