Memory Scan - Yaesu FTDX9000D - DATA MANAGEMENT Operation Manual

VFO M
AND EMORY
[ SQL ] knob
1. Set the transceiver up in the memory mode by press-
ing the [ V/M ] key, if necessary.
2. Rotate the Main receiver's (VFO-A) [ SQL ] control
so that the background noise is just silenced.
3. Press and hold in the microphone's [ UP ] or [ DOWN ] key
for 2 second to start scanning in the specified direction.
A A A A A
D D D D D VICE VICE VICE VICE
VICE
If the scanner halts on an incoming signal, the deci-
mal point between the "MHz" and "kHz" digits of
the frequency display will blink.
If the incoming signal disappears, scanning will
resume in about five seconds.
Q Q Q Q Q
UICK UICK UICK UICK UICK
If you have no interest in scanning, and wish to
prohibit the microphone's [ UP ] / [ DOWN ] keys
from initiating scanning, you may disable scanning
control from the microphone using Menu Item
"GENERAL 044 MIC SCAN" (set it to "DIS-
ABLE").
Page 134
S
CANNING
M
EMORY
P P P P P
OINT OINT OINT OINT OINT
S
CAN
[ V/M ] key
A A A A A
D D D D D VICE
During Memory Group operation, only the
channels within the current Memory Group will
be scanned.
If the scan has paused on a signal, pressing the
microphone's [ UP ] or [ DOWN ] key will cause
scanning to resume instantly.
If you press the microphone's PTT switch dur-
ing scanning, the scanner will halt at once.
Pressing the PTT switch during scanning will
not cause transmission, however.
You may select the manner in which the scan-
ner resumes while it has paused on a signal,
using Menu item "GENERAL 045 MIC
SCAN RESUME." During memory scanning,
the default "TIME" setting will cause the scan-
ner to resume scanning after five seconds; you
may change it, however, to resume only after
the carrier has dropped out, if you like See page
149.
FT 9000D O
DX
VICE VICE VICE VICE
M
PERATION ANUAL