Band Stack Operation; Cw Decode; Audio Peak Filter - Yaesu FTDX101D Operation Manual

Band Stack Operation

The FTDX101D utilizes a triple band-stack VFO
selection technique that permits storing of up to
three favorite frequencies and modes onto each
band VFO register.
A typical setup, for the 14 MHz band, might be
arranged like this:
1. Program 14.0250 MHz, CW Mode, then press
the [14] key.
2. Program 14.0800 MHz, RTTY Mode, then
press the [14] key.
3. Program 14.1950 MHz, USB Mode, then
press the [14] key.
With this configuration, successive momentary
presses of the [14] MHz band key will allow you
to step sequentially through these three VFOs.

CW Decode

Alphanumeric Morse code can be decoded and
displayed as text on the display.
Interfering signals, noise, phasing, code accura-
cy, and the like may prevent accurate message
copy.
1. Press the [CW] key to set the operating mode
to CW.
2. Press the [FUNC] key.
3. Touch [DECODE] .
The CW DECODE screen is displayed, and
the decoded message is displayed on the
screen.
CQ CQ CQ DE JA1YOE K
when a CW signal is not being received, touch [DEC
LVL] and then rotate the [MULTI] knobto adjust the
threshold level.
4. To cancel the CW decode function, touch
[DEC OFF].
Audio Peak F i l t e r
1. Press the [APF] key.
2. Rotate the [CONT/APF] knob to the left or
right to reduce any interference.
peak center frequency setting to "0 Hz".
while tuning the SHIFT knob.
To exit from APF operation, press the [APF] key
again.
SUB band
MAIN band
23