Operation On The 60-Meter Band (U.s. Version) - Yaesu FTDX9000D - DATA MANAGEMENT Operation Manual

O
PERATION ON THE
The recently-released 60-meter band is covered, in the FT
channels are set to USB, and they appear between the "last" PMS channel ("P9U") and the first "regular" memory channel
(Channel 1).
To operate on the 60-meter band channels:
Press the [ V/M ] switch, if necessary, to enter the
1
Memory mode. A memory channel number will ap-
pear in the multi-panel window.
2. Press the [ MCH/GRP ] key momentarily, if necessary,
to enable recalling a memory channel by the [ CLAR/
VFO-B ] knob. The Red LED inside the switch will
light up.
A A A A A
D D D D D VICE VICE VICE VICE VICE
If the Red LED imbedded in the [ MCH/GRP ] switch
does not light up, check to be sure that the orange
lamp to the right of the [ CLAR/VFO-B ] knob is not
illuminated. It is, press the [ A/B ] switch to make it go
out, then press the [ MCH/GRP ] key again.
3. Rotate the [ CLAR/VFO-B ] knob to select the desired
60-meter band channel.
Page 132
60-M B
AND ( U.S. V
ETER
DX
)
ERSION
9000D, by five special, fixed memory channels. These
[ V/M ] key [ MCH/GRP ] key
Be sure to observe all current regulations regarding Ef-
fective Radiated Power (E.R.P.) while operating on the
60-meter band.
C N
HANNEL UMBER
US1
US2
US3
US4
US5
FT 9000D O
DX
[ CLAR/VFO-B ] knob
F
REQUENCY
5.3320 MHz
5,3480 MHz
5.3680 MHz
5.3730 MHz
5.4050 MHz
M
PERATION ANUAL