How To Set Up The Simrad Pi Catch Monitoring System Interface - Simrad ES70 - INSTALLATION REV A Installation Manual

Simrad ES70
5 In the
Select Inputs
to connect it.
• : This setting allows you to communicate with the Simrad ITI system.
ITI
Values for trawl opening and distance must be entered manually in the
dialog.
The following proprietary telegram formats are supported:
– DBS Depth below surface on page 161
– DBS Depth of trawl below surface on page 170
– HFB Trawl headrope to footrope and bottom on page 170
6 Click to save the current settings and close the dialog.
OK
7 In the
I/O Setup
button to open the
In the
8
Serial Setup
9 Click to save the current settings and close the dialog.
OK
10 In the dialog, click on the chosen port to select it, then click the
I/O Setup
button to open the
In order to monitor the data flow, the ITI system must be active and transmitting
information to the ES70.
11 If the data flow is operational, close all dialogs.
How to set up the Simrad PI Catch monitoring system
interface
Communication with the Simrad PI Family catch monitoring systems is based on NMEA
and proprietary telegrams.
Supported telegram formats
• DBS Depth below surface on page 161
• PSIMP.D PI Sensor data on page 171
Wiring procedure for serial communication
1 Locate a free RS-232 serial port that can be used to connect the PI system.
On the ES70 computer, connect the receive signal
2
on pin 3, and
Tx
→ Generic RS-232 Serial line on page 42
3 On PI44 and PI54, use either connector
signal on pin 8, the transmit signal
Rx
→ PI44/54 serial line on page 61
On PI30 and PI32, use connector
4
transmit signal
Tx
→ PI30/32 serial line on page 62
88
dialog, locate the
ITI
dialog, click on the chosen port to select it, then click the
dialog.
Serial Setup
dialog, enter the relevant parameters to set up the port.
dialog.
Port Monitor
on pin 5.
ground
NMEA
on pin 1, and
ground
on the left side, and click the [>] button
on pin 2, the transmit signal
Rx
or . Connect the receive
NMEA1 NMEA2
on pin 6, and
Tx ground
. Connect the receive signal
on pins 2 and 4.
Trawl
Setup
Monitor
on pins 7 and 9.
on pin 3, the
Rx
343522/A