Storage Prior To Installation Or Use - Simrad ES70 - INSTALLATION REV A Installation Manual

Simrad ES70
Ensure that all available lifting lugs are used. Ensure the unit remains under control
during the operation to avoid damage to the unit, equipment or personnel.
Heavy units may be transported using a forklift truck. Special attention must then be
paid to the position of the unit's centre of gravity. The units must be properly secured to
the truck.

Storage prior to installation or use

When a system, a unit or a spare part has been delivered to the customer, it may be
subject to long time storage prior to installation and use. During this storage period,
certain specifications must be met. The equipment must be preserved and stored in such
a way that it does not constitute any danger to health, environment or personal injury.
The equipment must be stored in its original transportation crate.
1
2 Ensure that the units are clearly separated in the shelves and that each unit is easily
identifiable.
3 The crate must not be used for any purpose for which it was not intended (eg. work
platform etc.).
4 The crates must not be placed on top of each other, unless specific markings permit
this.
5 The crates must not be placed directly on a dirt-floor.
Do not open the crate for inspection unless special circumstances permit so.
6
• "Special circumstances" may be suspected damage to the crate and its content, or
inspections by civil authorities.
• If any units are damaged, prepare an inspection report stating the condition of the
unit and actions taken. Describe the damage and collect photographic evidence if
possible. Re-preserve the equipment.
• If the units are not damaged, check the humidity absorbing material. If required,
dry or replace the bags, then re-pack the unit(s) according to the packing
instructions.
If the crate has been opened, make sure that is it closed and sealed after the
7
inspection. Use the original packing material as far as possible.
The storage room/area must be dry, with a non-condensing atmosphere. It must
8
be free from corrosive agents.
9 The storage area's mean temperature must not be lower than -30° C, and not warmer
than +70° C. If other limitations apply, the crates will be marked accordingly.
10 The crate must not be exposed to moisture from fluid leakages.
11 The crate must not be exposed to direct sunlight or excessive warmth from heaters.
12 The crate must not be subjected to excessive shock and vibration.
178
343522/A