Es38-10 Transducer - Simrad ES70 - INSTALLATION REV A Installation Manual

Simrad ES70
ES38–10 transducer
This is the termination of the transducer cable from the ES38–10 split-beam transducer to
the transducer socket on the ES60 and EK60 General Purpose Transceiver Unit (GPT).
The other end of the cable is permanently fixed to the transducer.
There are four pairs in the transducer cable, each with one black and one white cable.
Each pair is marked with a small label identifying the transducer section. Pair number
4 is not used.
If you need to splice the transducer cable, it is very important to use the correct cable,
and to avoid ground loops. We strongly recommend the use of a junction box. We also
recommend that you install the transducer cable in a steel conduit.
For more information, see:
• Transducer cable splicing on page 142
• Steel conduit on page 142
• GPT Transducer plug connection on page 107
70
343522/A