Simplified System Diagrams - Simrad ES70 - INSTALLATION REV A Installation Manual

A twisted pair Ethernet cable connects the General Purpose Transceiver (GPT) to the
computer. The distance between the computer and the General Purpose Transceiver can
be extended up to maximum 100 meters.
If more than one transceiver is used, a small Ethernet switch is required to connect the
General Purpose Transceivers to the computer.
Standard single beam transducer
The ES70 must be connected to one or more transducers.
A wide range of operational frequencies are available.
For more information about the single beam transducers provided by Simrad, consult
www.simrad.com.
Split–beam transducer
The ES70 can be used with Simrad's advanced split-beam transducers. These transducers
are available at frequencies ranging from 18 to 200 kHz.
For more information about the split–beam transducers provided by Simrad, consult
www.simrad.com.

Simplified system diagrams

The system diagrams provided show examples on how a ES70 system may be set up.
Figure 3 System diagram with a single General Purpose Transceiver
A Display Unit
B Processor Unit (computer)
General Purpose Transceiver (GPT)
C
Transducer(s)
D
343522/A
Simrad ES70
13