Cable glands for small hulls
This cable glands made of plastic is designed for those smaller vessels that do not need
to be classified.
A
Packing nut (bronze). Make sure that you do not to damage the transducer cable
by tightening the packing nut too hard!
B
Rubber gasket
C
Plastic disk
Rubber gasket
D
Stuffing tube
E
F
Backing nut (bronze)
G
Backing washer (plastic)
O-ring 42.5 x 3.0 N
H
I
O-ring 39.5 x 3.0 N
J
Cable to the echo sounder (or a junction box)
Stuffing tube hole diameter: 36 mm ±1.5 mm.
Apply ample amount of sealant between the backing washer (H) and the hull plate.
The cable gland kit contains all the listed parts, except the sealant.
Note
The two O-rings must be clean, in good condition and free of cuts or other defects which
could affect their watertight integrity.
343522/A
Transducer Installation
141