Deep Water, Split Beam Transducer - Simrad ES70 - INSTALLATION REV A Installation Manual

Deep water, split beam transducer

This is the termination of the transducer cable from a deep water transducer. This
transducer is designed to be used towed bodies. The cable is equipped with a watertight
connector. The other end of the cable is permanently fixed to the transducer.
If you need to splice the transducer cable, it is very important to use the correct cable,
and to avoid ground loops. We strongly recommend the use of a junction box. We also
recommend that you install the transducer cable in a steel conduit.
For more information, see:
• Transducer cable splicing on page 142
• Steel conduit on page 142
• GPT Transducer plug connection on page 107
343522/A
ES70 Cable layout
73