How To Modify An Ip Address - Simrad ES70 - INSTALLATION REV A Installation Manual

Simrad ES70
On the sub-menu, click
dialog.
Observe that current frequency channels are listed in the dialog.
3
Each transceiver contains one or more frequency channels. The phrase is used to
identify the combination of a transceiver, transducers and the frequencies offered.
Split beam transceivers contain only one channel each. The upper part of the
Transceiver Installation
or have been, installed on the ES70. For each channel, a status label is provided.
• : The frequency channel is already in use, probably by another echo sounder
Busy
on the same network. You can not connect to this channel.
• : This frequency channel is connected to you ES70 system.
Installed
• : This frequency channel can not be used.
Lost
4 On the frequency channel you wish to disconnect, set the transducer type to None.
Observe that the status for the relevant frequency channels changes to Available.
5
6 Click to save the current settings and close the dialog.
OK

How to modify an IP address

The transceivers are provided by Simrad readily set up with a fixed Ethernet address and
an IP address. If your ES70 uses two transceivers with identical frequencies, these will
by default have different Ethernet addresses, but identical IP addresses. In order for your
system to work, all transceivers must have unique IP addresses.
Click the icon under the
1
Setup
Click
2
Installation
On the sub-menu, click
dialog.
3 Observe that the current frequency channels are listed in the dialog.
Click once on the frequency channel you wish to modify.
4
5 Observe that the relevant transceiver parameters are shown in the
field
Information
82
Transceiver Installation
dialog displays a list of frequency channels which either are,
menu to open the
Main
to open the
Installation
Transceiver Installation
to open the
Transceiver Installation
sub-menu.
Setup
sub-menu.
to open the
Transceiver Installation
Transceiver
343522/A