Simrad ES70 - INSTALLATION REV A Installation Manual page 126

Simrad ES70
Example: Small circular transducer
The illustration below shows a typical transducer blister designed for a small transducer.
The same blister design principles as for a large transducer apply.
Figure 29 Small circular transducer
A Streamlined
blister
Mounting ring
B
C Clamping ring
D Guide
Air outlet
E
Forward
F
G Transducer
cable
Note that the transducer cable must be provided with a cable loop inside the blister.
Observe the vertical forward edge of the blister. This will guide the water to each side
of the blister.
124
343522/A