How To Set Up The Motion Sensor Interface - Simrad ES70 - INSTALLATION REV A Installation Manual

Simrad ES70
If you choose Auto, the ES70 will automatically choose among the incoming
information according to a predefined priority list.
d If applicable, define the
4 Click to save the current settings and close the dialog.
OK

How to set up the motion sensor interface

The ES70 Fish finding echo sounder can accept inputs from both analogue and digital
heave sensors. A sensor with an analogue output is connected directly to the
connector on the General Purpose Transceiver, while a digital sensor is connected to one
of the serial inputs using RS-232.
If more than one transceiver is used by the echo sounder system, the analogue sensor is
connected to only one of them.
Supported telegram formats
• Sounder/TSS1 Motion protocol on page 173
• Simrad EM Attitude 1000 on page 168
• Simrad EM Attitude 3000 on page 169
Wiring procedure
Locate a free RS-232 serial port that can be used to connect the sensor.
1
2 On the ES70 computer, connect the receive signal
→ Generic RS-232 Serial line on page 42
On the motion sensor, wire as described in the relevant documentation.
3
Setup procedure
This procedure explains how the ES70 can be set up to receive motion sensor information
on a serial port.
1 Click the icon under the
Setup
2 Click
Installation
On the sub-menu
3 In the
I/O Setup
information.
4 Click on the chosen port to select it, then click the
dialog.
Inputs
92
Talker ID
menu to open the
Main
to open the
Installation
to open the
I/O Setup
dialog, select which serial line to use to accept motion sensor
.
on pin 2, and
Rx
Setup
sub-menu.
dialog.
I/O Setup
button to open the
Input
Auxiliary
on pin 5.
ground
sub-menu.
Select
343522/A