Cable Gland For Wooden And Grp Hulls - Simrad ES70 - INSTALLATION REV A Installation Manual

Simrad ES70

Cable gland for wooden and GRP hulls

A bronze cable gland kit is available for wooden and glass-reinforced plastic (GRP)
vessels.
Packing nipple. Make sure that you do not damage the transducer cable by
A
tightening the packing nipple too hard!
B Washers
Rubber gaskets
C
D Hole diameter 28 mm
E Steel conduit
Cable to the echo sounder (or a junction box)
F
The cable gland kit includes all of the necessary parts needed to install the unit except
screws.
Simrad recommends that a one inch steel conduit (that the transducer cable will be
run through) with an inside threaded diameter of three-quarter inches is attached to
the gland's packing nipple. This connection must be watertight, and the conduit must
extend to above the vessel's water line.
140
343522/A