Setup Procedure; Administration Of Frequency Channels - Simrad ES70 - INSTALLATION REV A Installation Manual

Simrad ES70
3 Connect a "straight" cable from the computer's Ethernet socket to the "uplink"
socket on the Ethernet switch.
→ RJ45 Ethernet, straight on page 49
Connect "straight" cables from Ethernet switch's remaining sockets to each of the
4
General Purpose Transceivers.

Setup procedure

Note that you will only need to carry out this procedure if you set up an ES70 system
using a locally purchased computer!
This procedure is valid for Microsoft Windows XP.
1 On the ES70, exit the echo sounder program, and access the
2 Click the button in the bottom left corner of the desktop.
Start
On the menu, select
3 On the
Control Panel
Double-click on
4
dialog.
5 At the bottom of the dialog, click
6 In the
Local Area Connection Properties
and click
Properties
Observe that the
7
8 Click
Use the following IP address
Observe that the Subnet mask and Default gateway addresses appear automatically.
You do not need to change these.
9 Click to exit the
Ok
10 Click to exit the
Ok
11 Click to exit the
Close

Administration of frequency channels

Use the following procedures to install, modify or delete frequency channels from the
echo sounder setup.
General Purpose Transceivers (GPT) units physically connected to the echo sounder's
Ethernet interface are identified automatically by the system. When you open the
Transceiver Installation
frequency transceiver occupies one entry in the list, and a dual frequency transceiver
occupies two. Each entry is identified as a frequency channel, and the line displays the
parameters for the channel. Entries in the frequency channel list are shown in black,
green or red colour identifying its current status.
80
, and then
Settings
, select
Network connections
Local Area Connection
Properties
.
Internet Protocol (TCP/IP) Properties
, and enter IP address: 157.237.14.12.
Internet Protocol (TCP/IP) Properties
Local Area Connection Properties
Local Area Connection Status
dialog from the
Setup
.
Control Panel
.
to open the
Local Area Connection Status
.
dialog, select
Internet Protocol (TCP/IP)
dialog opens.
dialog.
dialog.
dialog.
menu, a list will be provided. A single
.
Desktop
,
343522/A