How To Install A Frequency Channel; How To Disconnect A Frequency Channel - Simrad ES70 - INSTALLATION REV A Installation Manual

How to install a frequency channel

Click the icon under the
1
Setup
2 Click
Installation
On the sub-menu, click
dialog.
In the
3
Transceiver Installation
The ES70 will automatically search the network for available transceivers.
Observe that available frequency channels are listed in the dialog.
4
Each transceiver contains one or more frequency channels. The phrase is used to
identify the combination of a transceiver, transducers and the frequencies offered.
Split beam transceivers contain only one channel each. The upper part of the
Transceiver Installation
or have been, installed on the ES70. For each channel, a status label is provided.
• : The frequency channel is already in use, probably by another echo sounder
Busy
on the same network. You can not connect to this channel.
• : This frequency channel is connected to you ES70 system.
Installed
• : This frequency channel can not be used.
Lost
5 Select a frequency channel that is available, and choose the correct transducer in
the spin box.
Note
This is a critical task. You must ensure that the correct transducer is selected. If
you connect the transceiver to a transducer that can not handle the power rating, it
may be damaged beyond repair.
Observe that the status for the relevant frequency channels changes to Installed.
6
Click to save the current settings and close the dialog.
7
OK

How to disconnect a frequency channel

1 Click the icon under the
Setup
Click
2
Installation
343522/A
menu to open the
Main
to open the
Installation
Transceiver Installation
dialog, click
dialog displays a list of frequency channels which either are,
menu to open the
Main
to open the
Installation
Connecting the transceiver
sub-menu.
Setup
sub-menu.
to open the
Transceiver Installation
.
Browse
sub-menu.
Setup
sub-menu.
81