How To Set Up The Ethernet Output Interface - Simrad ES70 - INSTALLATION REV A Installation Manual

Simrad ES70

How to set up the Ethernet output interface

The ES70 can communicate with an external devices that can benefit from the processed
data. Such devices include the
controlled by the
Ethernet Output
The following telegrams may be exported:
• Parameter
• Vessel log
• Navigation
• Motion sensor
• Depth
• Echogram
• Echo trace
The interface will require the absolute identity of the remote UDP port and the remote IP
address.
The settings required for the Olex system are specified in the
description in the ES70 Reference Manual.
Wiring procedure
1 Locate the Ethernet port you wish to use.
2 If no Ethernet port is available, an Ethernet switch may be inserted between the
computer and the transceiver.
If you connect an Ethernet cable directly between the ES70 computer and a remote
3
computer, you must use a Ethernet cable. If you connect the other computer by
means of an Ethernet switch, you must use "straight" Ethernet cables.
Setup procedure
1 Click the icon under the
Setup
2 Click
Ethernet Output
Define the
3
Remote Port
4 Define the
Remote IP Address
Set
5
Communication Mode
6 In the
Ethernet Output
dialog.
7 On the
Datagram
Click to save the current settings and close the dialog.
8
OK
86
chart plotter system. This communication is
Olex
dialog.
menu to open the
Main
to open the
Ethernet Output
.
for the computer you wish to export the information to.
to Broadcast.
dialog, click
EK500 Datagram
tab, define which datagrams you wish to export.
EK500 Datagram
sub-menu.
Setup
dialog.
to open the
EK500 Datagram
dialog
343522/A