Simrad ES70
This chapter describes how to install the ES70 software, how to upgrade, how to obtain a
software license, and finally how to remove the software installation.
Topics
•
How to install the ES70 software on page 76
•
How to obtain the ES70 license on page 77
•
How to upgrade the ES70 software on page 77
•
How to remove the ES70 software on page 78
How to install the ES70 software
Use this procedure if you need to install the software on a new computer. Note that
minimum hardware and software requirements must be met by the computer.
1
Power up the computer.
2
Insert the ES70 CD-ROM.
3
Observe that the installation program opens.
If the installation program does not start automatically, use a file manager to access
the CD folder. Double-click on the
4
Allow the ES70 installation to run. Follow the instructions provided.
5
Once the installation has been completed, double-click the ES70 icon on the desktop
to start the application.
When the ES70 starts, you may see a dialog requesting permission to upgrade the
firmware on the transceiver. This happens if the firmware on the transceiver is older
than the firmware provided as a part of the ES70 software. Since functionality
on the ES70 may depend on the firmware in the transceiver, click
the transceiver.
6
If you use
Windows 7
a
Observe that
about the network.
Select Public, and click
b
Observe the start-up procedure in the Getting started chapter.
7
76
Software installation
Setup.exe
operating system:
will open a dialog requesting information
Windows 7 Firewall
Allow access
file to start the installation.
.
to upgrade
Yes
343522/A