Cable Connection - Simrad IS20 Manual

7.3 Cable connection

The IS20 may be connected to:
− a SimNet network using SimNet cables
− an NMEA2000 system
− an NMEA0183 output port
SimNet/
NMEA2000
SimNet
The SimNet cable system with very small plugs in both
ends makes it easy to run the cables. Only 10 mm (3/8")
holes are required through panels and bulkheads.
The SimNet accessory program contains the necessary
items to make a successful installation. Refer SimNet
cables and accessories, page 74.
SimNet cables
A SimNet unit has one or two yellow SimNet connectors.
There are no dedicated "in" or "out" connectors.
Route the SimNet cables with the figures on page 51, 52
and 53 as a guideline. Select cables and accessories from
the SimNet accessory program.
Connect products with two SimNet connectors in a daisy
chain and use drop cables and T-joiners when required.
For cable extension in-line cable joiners are available.
Total length of SimNet cable installed in a system should
not exceed 150 meter (500')!
NMEA0183 In
SimNet/
NMEA2000
Installation | 49