Sip Configuration Menu (Sip Phones Only); Sip General Configuration Menu; Line Settings Menu - Cisco 7970G - IP Phone VoIP Administration Manual

Chapter 4 Configuring Settings on the Cisco Unified IP Phone

SIP Configuration Menu (SIP Phones Only)

SIP General Configuration Menu

Table 4-5 SIP General Configuration Menu Options
Option
Preferred CODEC
Out of Band DTMF Displays the configuration of the
Register with Proxy Displays if the phone must register with
Register Expires
Cisco Unified IP Phone 7970G/7971G-GE Administration Guide for Cisco Unified Communications Manager 6.1
OL-14626-01
The SIP Configuration menu is available on SIP phones. This menu contains these
sub-menus:
SIP General Configuration Menu, page 4-19
•
• Line Settings Menu, page 4-21
The SIP General Configuration menu displays information about the configurable
SIP parameters on a SIP phone.
Description
Displays the CODEC to use when a call
is initiated. This value will always be
set to none.
out-of-band signaling (for tone
detection on the IP side of a gateway).
The Cisco Unified IP Phone (SIP)
supports out-of-band signaling by
using the AVT tone method. This value
will always be set to avt.
a proxy server during initialization.
This value will always be set to true.
Displays the amount of time, in
seconds, after which a registration
request expires.
Table 4-5 describes the options in this menu.
To Change
Display only—cannot configure.
Display only—cannot configure.
Display only—cannot configure.
From Cisco Unified Communications
Manager Administration, choose
Device > Device Settings > SIP
Profile.
Device Configuration Menu
4-19